How To Replace Outdoor Recessed Lighting

Replacing outdoor recessed lighting is a task that can be completed by most DIYers with basic electrical knowledge. By following these steps, you can safely and easily update the look of your outdoor space.

Safety First

Before you begin, it is important to turn off the power to the circuit that controls the recessed lighting. This can be done by flipping the breaker or removing the fuse that corresponds to the circuit. Once the power is off, you can proceed with the replacement process.

Removing the Old Fixture

To remove the old fixture, you will need to use a putty knife or flathead screwdriver to pry the trim ring loose from the ceiling. Once the trim ring is loose, you can pull it down and disconnect the wires from the old fixture. Be sure to note which wire is connected to the black terminal and which is connected to the white terminal, as you will need to connect the new fixture in the same way.

Installing the New Fixture

To install the new fixture, simply connect the wires from the fixture to the wires from the ceiling. Be sure to twist the wires together securely and then cap them with wire nuts. Once the wires are connected, you can push the new fixture into the ceiling and secure it with the trim ring.

Before you turn the power back on, be sure to test the new fixture to make sure that it is working properly.

Tips

Here are a few tips to help you replace your outdoor recessed lighting:

Use a ladder to reach the light fixture.
Wear gloves to protect your hands from sharp edges.
Be careful not to damage the wires or the ceiling.
If you are unsure about how to replace the light fixture, consult with a qualified electrician.

By following these steps and tips, you can safely and easily replace your outdoor recessed lighting.