How To Replace Outdoor Carpet On Concrete Steps

How to Replace Outdoor Carpet on Concrete Steps

Replacing outdoor carpet on concrete steps is a straightforward task that can be completed in a few hours. By following these simple steps, you can ensure that your steps are safe and look their best.

Materials You Will Need:

New outdoor carpet
Carpet adhesive
Caulk gun
Utility knife
Tape measure
Scissors
Broom or vacuum cleaner

Step 1: Remove the Old Carpet

Begin by removing the old carpet from the steps. Use a utility knife to carefully cut the carpet around the edges of the steps. Once the carpet is cut, peel it away from the steps and remove any remaining adhesive.

Step 2: Clean the Steps

Once the old carpet is removed, sweep or vacuum the steps to remove any dirt or debris. This will help the new carpet adhesive to adhere properly.

Step 3: Apply the Carpet Adhesive

Apply a bead of carpet adhesive around the perimeter of each step. Use a caulk gun to apply the adhesive evenly. Be sure to apply enough adhesive to hold the carpet in place, but not so much that it will squeeze out from under the carpet.

Step 4: Install the New Carpet

Place the new carpet on the steps, aligning it with the edges of the adhesive. Press the carpet firmly into the adhesive to ensure that it is secure. Trim any excess carpet from the edges of the steps.

Step 5: Allow the Adhesive to Dry

Allow the carpet adhesive to dry completely before using the steps. The drying time will vary depending on the type of adhesive used. Check the manufacturer's instructions for the specific drying time.