How To Remove Indoor Outdoor Carpet Glue From Concrete

Removing indoor-outdoor carpet glue from concrete can be a challenging task, but it's not impossible. By using the right tools and techniques, you can remove the glue without damaging the concrete.

What You'll Need:

* Safety glasses * Dust mask * Gloves * Putty knife * Hammer * Chisel * Heat gun * Chemical stripper * Concrete cleaner * Bucket * Scrub brush * Mop

Step 1: Safety First

Put on your safety glasses, dust mask, and gloves before you begin. The chemicals in the glue stripper can be hazardous if they're inhaled or come into contact with your skin.

Step 2: Remove Loose Glue

Use the putty knife to scrape away any loose glue from the concrete. Be careful not to gouge the concrete.

Step 3: Break Up the Glue

If the glue is still too thick to scrape away, use the hammer and chisel to break it up into smaller pieces. Hold the chisel at a 45-degree angle to the concrete and tap it with the hammer.

Step 4: Heat the Glue

Use the heat gun to heat the glue. This will make it easier to remove. Hold the heat gun about 6 inches away from the concrete and move it back and forth until the glue starts to soften.

Step 5: Apply Chemical Stripper

Apply the chemical stripper to the softened glue. Follow the instructions on the product label for the correct amount of time to let the stripper work.

Step 6: Scrape Away the Glue

Use the putty knife to scrape away the softened glue. The glue should come off easily.

Step 7: Clean the Concrete

Mix the concrete cleaner with water in a bucket according to the product label. Use the scrub brush to scrub the concrete clean. Rinse the concrete with water and mop it dry.

Tips:

* If the glue is very thick, you may need to repeat steps 4-6 several times. * Be patient. Removing carpet glue from concrete can take some time. * If you're not sure how to remove the glue, it's always best to consult with a professional.